Wire Cut EDM Manufacturer

Fine Finish Cutting

Good surface finish, Ra0.35µm is standard, the best can reach Ra0.06µm with MST-Ⅲ

  • The best surface finish is Ra 0.06μm.
  • FPGA programmable chip is applied. Added voltaic arc eliminate technology, control the energy of finish cutting precisely.
  • The stability of the machine is the key point, there is only 1μm offset at the last cut, if the backlash bigger than 1μm, the surface finish will not uniform.
  • Heat balance design, and high precision path control, to make sure the surface of cutting is uniform.
This website uses cookies to ensure you get the best experience on our website.